{
  "document": {
    "acknowledgments": [
      {
        "summary": "This vulnerability was found during the resolution of a Cisco TAC support case."
      }
    ],
    "category": "csaf_security_advisory",
    "csaf_version": "2.0",
    "notes": [
      {
        "category": "summary",
        "text": "A vulnerability in the access control list (ACL) functionality of the standby route processor management interface of Cisco IOS XR Software could allow an unauthenticated, remote attacker to reach the configured IP addresses on the standby route processor management Gigabit Ethernet Management interface.\r\n\r\nThe vulnerability is due to a logic error that was introduced in the Cisco IOS XR Software, which prevents the ACL from working when applied against the standby route processor management interface. An attacker could exploit this vulnerability by attempting to access the device through the standby route processor management interface.\r\n\r\nThere are no workarounds that address this vulnerability.\r\n\r\nThis advisory is available at the following link:\r\nhttps://sec.cloudapps.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-xracl-zbWSWREt [\"https://sec.cloudapps.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-xracl-zbWSWREt\"]",
        "title": "Summary"
      },
      {
        "category": "general",
        "text": "At the time of publication, this vulnerability affected Cisco devices if they were running a vulnerable release of Cisco IOS XR Software and had dual route processors and an ACL configured on the standby route processor management interface.\r\n\r\nAt the time of publication, the release information in the following table(s) was accurate. See the Details section in the bug ID(s) at the top of this advisory for the most complete and current information.\r\n        Cisco IOS XR Software Train  Affected Releases            6.7  6.7.1      7.0  7.0.2, 7.0.11, 7.0.12      7.1  7.1.1, 7.1.15",
        "title": "Vulnerable Products"
      },
      {
        "category": "general",
        "text": "Only products listed in the Vulnerable Products [\"#vp\"] section of this advisory are known to be affected by this vulnerability.",
        "title": "Products Confirmed Not Vulnerable"
      },
      {
        "category": "general",
        "text": "This vulnerability applies to both IPv4 and IPv6 ACLs.",
        "title": "Details"
      },
      {
        "category": "general",
        "text": "There are no workarounds that address this vulnerability.\r\n\r\nHowever, administrators can choose one of the following mitigation options to help decrease any attack surface:\r\n\r\nFor features that leverage the TTYs, apply an ACL to all VTY lines. This will mitigate this vulnerability for those applications, as shown in the following example:\r\n\r\n\r\nline template vty\r\n access-class ingress MGMT_ACL_V4\r\n!\r\nvty-pool default 0 9 line-template vty\r\n\r\nFor features that leverage a feature-specific ACL, apply an ACL to the feature itself. This will mitigate this vulnerability for those applications as shown in the following examples:\r\n\r\nNETCONF\r\n\r\n\r\nssh server netconf ipv4 access-list MGMT_ACL_V4\r\n\r\nSSH\r\n\r\n\r\nssh server ipv4 access-list MGMT_ACL_V4\r\n\r\nTelnet\r\n\r\n\r\ntelnet ipv4 server max-servers 3 access-list MGMT_ACL_V4\r\n\r\nFor features that are controlled through management plane protection, apply an out-of-band management plane protection policy, as shown in the following example:\r\n\r\n\r\ncontrol-plane\r\n management-plane\r\n  out-of-band\r\n   interface MgmtEth0/RSP0/CPU0/0\r\n    allow all peer\r\n     address ipv4 192.168.1.1\r\n    !\r\n   !\r\n   interface MgmtEth0/RSP1/CPU0/0\r\n    allow all peer\r\n     address ipv4 192.168.1.1\r\n    !\r\n   !\r\n\r\nNote: Applications that are accessible on the device that do not require a TTY to be allocated and do not support application-specific ACLs are still exposed.",
        "title": "Workarounds"
      },
      {
        "category": "general",
        "text": "When considering software upgrades [\"https://sec.cloudapps.cisco.com/security/center/resources/security_vulnerability_policy.html#fixes\"], customers are advised to regularly consult the advisories for Cisco products, which are available from the Cisco Security Advisories and Alerts page [\"https://www.cisco.com/go/psirt\"], to determine exposure and a complete upgrade solution.\r\n\r\nIn all cases, customers should ensure that the devices to be upgraded contain sufficient memory and confirm that current hardware and software configurations will continue to be supported properly by the new release. If the information is not clear, customers are advised to contact the Cisco Technical Assistance Center (TAC) or their contracted maintenance providers.\r\n      Fixed Releases\r\nFor information about fixed software releases, see the Details section in the bug ID(s) at the top of this advisory.",
        "title": "Fixed Software"
      },
      {
        "category": "general",
        "text": "To learn about Cisco security vulnerability disclosure policies and publications, see the Security Vulnerability Policy [\"https://sec.cloudapps.cisco.com/security/center/resources/security_vulnerability_policy.html\"]. This document also contains instructions for obtaining fixed software and receiving security vulnerability information from Cisco.",
        "title": "Vulnerability Policy"
      },
      {
        "category": "general",
        "text": "The Cisco Product Security Incident Response Team (PSIRT) is not aware of any public announcements or malicious use of the vulnerability that is described in this advisory.",
        "title": "Exploitation and Public Announcements"
      },
      {
        "category": "general",
        "text": "This vulnerability was found during the resolution of a Cisco TAC support case.",
        "title": "Source"
      },
      {
        "category": "legal_disclaimer",
        "text": "THIS DOCUMENT IS PROVIDED ON AN \"AS IS\" BASIS AND DOES NOT IMPLY ANY KIND OF GUARANTEE OR WARRANTY, INCLUDING THE WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR USE. YOUR USE OF THE INFORMATION ON THE DOCUMENT OR MATERIALS LINKED FROM THE DOCUMENT IS AT YOUR OWN RISK. CISCO RESERVES THE RIGHT TO CHANGE OR UPDATE THIS DOCUMENT AT ANY TIME.\r\n\r\nA standalone copy or paraphrase of the text of this document that omits the distribution URL is an uncontrolled copy and may lack important information or contain factual errors. The information in this document is intended for end users of Cisco products.",
        "title": "Legal Disclaimer"
      }
    ],
    "publisher": {
      "category": "vendor",
      "contact_details": "Emergency Support:\r\n+1 877 228 7302 (toll-free within North America)\r\n+1 408 525 6532 (International direct-dial)\r\nNon-emergency Support:\r\nEmail: psirt@cisco.com\r\nSupport requests that are received via e-mail are typically acknowledged within 48 hours.",
      "issuing_authority": "Cisco product security incident response is the responsibility of the Cisco Product Security Incident Response Team (PSIRT). The Cisco PSIRT is a dedicated, global team that manages the receipt, investigation, and public reporting of security vulnerability information that is related to Cisco products and networks. The on-call Cisco PSIRT works 24x7 with Cisco customers, independent security researchers, consultants, industry organizations, and other vendors to identify possible security issues with Cisco products and networks.\r\nMore information can be found in Cisco Security Vulnerability Policy available at https://sec.cloudapps.cisco.com/security/center/resources/security_vulnerability_policy.html",
      "name": "Cisco",
      "namespace": "https://wwww.cisco.com"
    },
    "references": [
      {
        "category": "self",
        "summary": "Cisco IOS XR Software Standby Route Processor Gigabit Ethernet Management Interface Access Control List Bypass Vulnerability",
        "url": "https://sec.cloudapps.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-xracl-zbWSWREt"
      },
      {
        "category": "external",
        "summary": "Cisco Security Vulnerability Policy",
        "url": "https://sec.cloudapps.cisco.com/security/center/resources/security_vulnerability_policy.html"
      },
      {
        "category": "external",
        "summary": "https://sec.cloudapps.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-xracl-zbWSWREt",
        "url": "https://sec.cloudapps.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-xracl-zbWSWREt"
      },
      {
        "category": "external",
        "summary": "considering software upgrades",
        "url": "https://sec.cloudapps.cisco.com/security/center/resources/security_vulnerability_policy.html#fixes"
      },
      {
        "category": "external",
        "summary": "Cisco Security Advisories and Alerts page",
        "url": "https://www.cisco.com/go/psirt"
      },
      {
        "category": "external",
        "summary": "Security Vulnerability Policy",
        "url": "https://sec.cloudapps.cisco.com/security/center/resources/security_vulnerability_policy.html"
      }
    ],
    "title": "Cisco IOS XR Software Standby Route Processor Gigabit Ethernet Management Interface Access Control List Bypass Vulnerability",
    "tracking": {
      "current_release_date": "2020-06-17T16:00:00+00:00",
      "generator": {
        "date": "2022-10-22T03:04:21+00:00",
        "engine": {
          "name": "TVCE"
        }
      },
      "id": "cisco-sa-xracl-zbWSWREt",
      "initial_release_date": "2020-06-17T16:00:00+00:00",
      "revision_history": [
        {
          "date": "2020-06-17T13:53:55+00:00",
          "number": "1.0.0",
          "summary": "Initial public release."
        }
      ],
      "status": "final",
      "version": "1.0.0"
    }
  },
  "product_tree": {
    "branches": [
      {
        "branches": [
          {
            "category": "product_family",
            "name": "Cisco IOS XR Software",
            "product": {
              "name": "Cisco IOS XR Software ",
              "product_id": "CSAFPID-5834"
            }
          }
        ],
        "category": "vendor",
        "name": "Cisco"
      }
    ]
  },
  "vulnerabilities": [
    {
      "cve": "CVE-2020-3364",
      "ids": [
        {
          "system_name": "Cisco Bug ID",
          "text": "CSCvt55079"
        }
      ],
      "notes": [
        {
          "category": "other",
          "text": "Complete.",
          "title": "Affected Product Comprehensiveness"
        }
      ],
      "product_status": {
        "known_affected": [
          "CSAFPID-5834"
        ]
      },
      "release_date": "2020-06-17T16:00:00+00:00",
      "remediations": [
        {
          "category": "vendor_fix",
          "details": "Cisco has released software updates that address this vulnerability.",
          "product_ids": [
            "CSAFPID-5834"
          ],
          "url": "https://software.cisco.com"
        }
      ],
      "scores": [
        {
          "cvss_v3": {
            "baseScore": 5.3,
            "baseSeverity": "MEDIUM",
            "vectorString": "CVSS:3.0/AV:N/AC:L/PR:N/UI:N/S:U/C:N/I:L/A:N",
            "version": "3.0"
          },
          "products": [
            "CSAFPID-5834"
          ]
        }
      ],
      "title": "Cisco IOS XR Software Secondary Route Processor Gigabit Ethernet Management Interface Access Control List Bypass Vulnerability"
    }
  ]
}